header

Introduction to Clicker Training – Part 2, August 23, 2010

Charging the Clicker

By pairing the ‘click’ marker signal with a reward (small food treats), the dog learns that the sound predicts a treat.  This process is called charging the clicker.  You click and immediately give the dog a small treat.  Repeat 20 times.  At this stage we don’t care what your dog is doing; they just have to learn that the click predicts a treat.  After one or two sessions your dog will learn to associate the click sound with a treat.

How Does the Clicker Help Me Train My Dog?

When your dog does something you like, you mark it with a click and give the dog a treat.  Rewarded behaviors will be repeated so the dog will continue to do things that earned him a click in the past.  The clicker communicates the following information:

  • – I like the behavior you just did
  • – You have earned a reward for that behavior
  • – That behavior is now over

For example:

The dog starts to go into a sit position.  The dog hears the click as he is sitting and gets a treat.  You can either repeat that cycle or move onto a new behavior.  If you accidentally click, just feed the dog and start again.

Getting the Behavior to Happen

We use 3 primary methods to get desired behaviors.

  • Luring
  • Capture
  • Shaping

 Luring: Holding a food lure in your hand you motion the dog into a position such as sit or down.  Luring techniques are useful when first teaching a behavior but they must be faded quickly in order for the dog to truly learn.

Capture: Good trainers are observant. By observing the desired behaviors as they naturally occur and click/treating them, they will occur more often.  An example would be clicking as you notice your dog going into a down and then rewarding him.

Shaping: By shaping you would click and treat small portions of the desired final behavior.  For example if you were shaping a sit you would click/treat any small movement starting with the dog’s head coming up and the butt heading towards the floor.  Finally you get the complete sit behavior and click and treat for that.

Naming the Behavior

With new behaviors that the dog does not know well, we train the behavior first before we call it anything.  Naming the behavior (putting the behavior on Cue) is the last piece of the puzzle.  Dogs are not verbal and do not understand English!  So be patient and get the behavior to happen reliably before giving it a name.

 

Training a Simple Behavior – “Touch”

Charge up your clicker and then hold your non-clicker hand with a flat palm facing your dog, holding your target hand close to their nose. As they touch their nose to your target hand, C/T.  Using the concept of shaping, you may need to start by clicking and rewarding for just initial interest in the target hand, or just turning towards it.  Be patient. Eventually your dog will move his nose to your open palm.  Once they are freely touching the target hand, only click for actual touches.  Repeat 10 times, moving your hand slightly to the left and right and gradually further away by taking a couple of steps.  Keep repeating the variations.

Your dog is learning that it’s their actions that are causing you to C/T and the desired action is the nose to palm touch.  Your dog has now learned their first clicker behavior and you have had a chance to practice your clicker timing and treat delivery.  Once the dog can do several touches with you moving your target hand you can add the verbal cue “Touch” to the behavior.  Only say the cur once as the dog is in the process of touching the target hand.

Bookmark and Share

No comments so far. Leave a comment.

No comments yet.

Leave a comment

will not be published

Supported By : FyberSoft